i dont have the car yet. its a long story with my old car, but . . . . When i swap in an sr20 i was wondering what you guys though about using stillen side mount for a Z32 on my s13?? i want a more efficient i/c and the stillens are i belive 15% more efficient on the z32 so i thought it would be great for the SR. plus custom piping but im not worried abou that. plus it will be super low key compared to a huge front mount. what do you guys think???

 

How much is that going to run you? Why not just do a front mount??? You could do a small one.

 

im not sure how much it will be but it was just an idea. i thought it might be a little cheaper than a front mount

 

ebay intercoolers are cheap. HAHA.

 

they have 35% more suface area over the stock i/cs. i figure find some used ones that arent beat. som custom piping, i can take care of that, and im good to go. but depending on how much i can get 'em i might just go with the front mount.

 

cheap works!

 

the stillens are $792 new

 

Damn, ebay intercoolers are like $150. haha

 

jeez! that is cheap. well that might be the solution, haha

 

Just get a skinny one and you should be able to mount it in the front without removing your bumper support.

 

i dont mind removing the bumper support. dangerous but hey. performance over safety right? j/k. lol.

 

or if you dont trust ebay stuff you can get a Greddy M-Spec comes with intercooler all pipes and couplings and clamps everything for $350+

 

where at???

 

id like a blitz lm. i hear great things. plus im a huge blitz fanatic. lol

 

Well if thats what you want, then go for it. $700 is alot to spend on a side mount intercooler.