Testing the MAF. Am i doing this right? pics
#1
Testing the MAF. Am i doing this right? pics
I've been trying to test my MAF. I backprobed the Maf like the manual states but i've been wondering if I'm on the wrong setting.
My multimeter is a pocket multimeter from power tools
I'm supposed to backprobe the wire thats towards passenger side.. not the driver side right? Meaning if you were to look at the harness from your drivers seat.. it's the far right.. not the far left. (harness is between maf and driver) Correct?
when i check the maf its on the DC V side like this on 10.
[img=http://img120.imagevenue.com/loc111/th_40107_meter.jpg]
I get a reading of .8 at idle and 2.5 at 4k rpm on the ac10v like this. (the red)
[img=http://img9.imagevenue.com/loc40/th_40112_meter2.jpg]
When i click it to the AC V on 10(i dont have a picture but i just click it 4 times counterclockwise.. look at the above pictures). I get a little past 2 on the ac10v scale.
So my question is... Is it DC V (10) or AC V (10) that i should be using to test the MAF. And my second question... Am I reading it correctly on the needle? (the red scale where it says AC 10V right)
and on this image
the harness is disconnected. Are you backprobing or probing from the other side. I'm getting more confused.
sorry for all the questions.
My multimeter is a pocket multimeter from power tools
I'm supposed to backprobe the wire thats towards passenger side.. not the driver side right? Meaning if you were to look at the harness from your drivers seat.. it's the far right.. not the far left. (harness is between maf and driver) Correct?
when i check the maf its on the DC V side like this on 10.
[img=http://img120.imagevenue.com/loc111/th_40107_meter.jpg]
I get a reading of .8 at idle and 2.5 at 4k rpm on the ac10v like this. (the red)
[img=http://img9.imagevenue.com/loc40/th_40112_meter2.jpg]
When i click it to the AC V on 10(i dont have a picture but i just click it 4 times counterclockwise.. look at the above pictures). I get a little past 2 on the ac10v scale.
So my question is... Is it DC V (10) or AC V (10) that i should be using to test the MAF. And my second question... Am I reading it correctly on the needle? (the red scale where it says AC 10V right)
and on this image
the harness is disconnected. Are you backprobing or probing from the other side. I'm getting more confused.
sorry for all the questions.
Last edited by KeN VeRsUs RyU; 05-02-2006 at 05:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post
DriftX
For Sale - Engine / Drivetrain / Power
2
07-03-2007 04:13 PM
WILDACEXXX
For Sale - Engine / Drivetrain / Power
1
06-29-2007 09:14 AM
All Mighty KA-T
General
14
07-31-2006 08:40 PM
AceInHole
Private For Sale / Wanted
2
02-05-2004 07:23 PM