BOLT IN DIRECT FIT for 89-92 240sx, nothing else needed.
RB25det Motor, Tranny, ECU
Plug n Play mckinney harness for s13
mounts
custom One piece drive shaft.
CLutch Net CLuctch Kit.. 600hp rated
60-1 Garrett Turbo
38MM Tial Wastgate
Down Pipe
Hybrid 24x12x3 Intercooler
All intercooler piping

$8000 or $8500 Installed

will throw in 550cc injectors and q45 Maf


cyris@***.net

 

Why would you even post it in general? Moved to private sales and please follow the new guidlines for selling, thanks.

 

sorry

 

Would you be willing to part some of it out?

8k is expensive for whats there

Josh

 

every place charges 8000 for a stock rb25det installled.. this on has lots and lots of extras.

 

damn do0d, i dont know where you're looking for RB25DET motors and stuff cuz i've never seen an RB25DET over 4,000 (not installed, but i gurentee the install rate ant as much as the motor, or even 1/2...lol) RB26DETT ant even that much, prob 6,000 at most (from what i've seen)

But where are you located and how many miles on it, J/W, cuz i'm doing that swap in my s13, but i dont even have 1/2 that much $ to spend on that engine

 

Actually everyone, I did all the calculations and with all those upgrades + labor it runs to just below 8k or around 8k

 

I guess having those "friends" helps out. Ill have a stock RB25 and tranny and put in my car for less than 4k

Sppolin sorry for jakin your thread man. I might be interested in your turbo and stuff other than the motor/tranny

Thanks Bro

Josh

 

Is this the whole McKinney kit (motor & tranny mounts, downpipe, wiring harness, and one peice driveshaft)?

Also what manifold would come with it? The 60-1 is an external wastgate and would need an aftermarket manifold that comes with a flang for the wastgate.

 

its just the mckinnney wirring.. the mounts were made by Trevtec here in vegas as well as the downpipe.. and the driveshaft made by a local driveshaft guy..

as for the 60-1 we made an adapter box to make it all fit..

 

hmm....
very intresting. i'll put the word out.
how about $8000 shipped?

 

i can do that..

 

the word is out.

 

Just curious..how come you're abandoning the swap?

 

im gonna be doing the rb26dett.. and atempting the AWD conversion.. its never been done in the outside japan.. and its gonna take a bit of money