The nissan newb
01-25-2010, 01:53 PM
#1
Registered User
Thread Starter
Join Date: Jan 2010
Location: oklahoma
Posts: 18
The nissan newb
i bought a 1990 240SX Se hatch. KA24E
its a diamond in the rough.
it was sitting in a small junk car lot.
it was priced for 800$.
when i got ahold of it it had 227,000 miles
they said the car needed a new alternator, i had it replaced and threw on all new belts.
put new rear tires. had the front balenced.
i feel like it needs a new clutch and soon to be a new tranny.
when i checked the Tranny Fluid, it was empty( people take care of great cars)
changed the oil,filled the trany with fluid
i have never own a nissan before, ive been a honda guy for several year.
shh dont tell anyone.
i love my purchase.
i hope this forum can help me with information, tips and the missing part im looking for.
after the little maintenance, it is a awesome running car.
picture coming soon.
its a diamond in the rough.
it was sitting in a small junk car lot.
it was priced for 800$.
when i got ahold of it it had 227,000 miles
they said the car needed a new alternator, i had it replaced and threw on all new belts.
put new rear tires. had the front balenced.
i feel like it needs a new clutch and soon to be a new tranny.
when i checked the Tranny Fluid, it was empty( people take care of great cars)
changed the oil,filled the trany with fluid
i have never own a nissan before, ive been a honda guy for several year.
shh dont tell anyone.
i love my purchase.
i hope this forum can help me with information, tips and the missing part im looking for.
after the little maintenance, it is a awesome running car.
picture coming soon.
01-25-2010, 03:35 PM
#3
Registered User
Thread Starter
Join Date: Jan 2010
Location: oklahoma
Posts: 18
Does anyone know the about of tubing needed for exhaust for a 240sx?
i am thinking of doing my own 2 1/2" stainless tubing.
does anyone have pictures of the bends and degree's needed per each bend?
i am thinking of doing my own 2 1/2" stainless tubing.
does anyone have pictures of the bends and degree's needed per each bend?
01-25-2010, 04:20 PM
#7
Registered User
Thread Starter
Join Date: Jan 2010
Location: oklahoma
Posts: 18
i downloaded the pdf, it does not give the mapping need for creating exhaust.
once i get over my chest cold, i will get picture on here.
i am looking at creating my own strut bar, as well as CAI.
for the most part this is being my A to B car, until i can afford to mod.
the 240 seems to be a fun car to drive. a lot better then a honda civic
once i get over my chest cold, i will get picture on here.
i am looking at creating my own strut bar, as well as CAI.
for the most part this is being my A to B car, until i can afford to mod.
the 240 seems to be a fun car to drive. a lot better then a honda civic
