I am looking to put a VLSD out of an abs 95 S14 into a non-abs 95 S14. I was wondering if anyone could tell me what I will need to get off the abs car to put the VLSD in my car? Will my axles and driveshaft work or will I need the axles and driveshaft out of the abs car? Is there anything else needed for the swap? Thanks.

 

im sure you could of searched this ****.

But its will fit fine. Your drive shaft will move foward about 20mm or so.

Keep the ABS sensor in the diff, with out it; it may leak.

Done.