I know someone who can do your harness completely without any bugs. He'll probably charge less as well. I don't do the wiring myself because I really don't want to take the time to sit down and figure it out...I'd rather pay someone who does it all the time. As far as mounts go...anyone can make em for about $20-$30 of steel and some ingenuity. They really aren't much more than an apex with two flat sides...one for the rubber bushing and the other for the engine itself....it would be an easy task.

Night

 

Guess he's right, if you have the time a little bit a know how and all the equipment you could make your own. Like I said as of now I only know one place where you can get everthing for a clean bolt in and plug and play setup. So untill anyone else makes kits your choice is limited to Mickinney motorsports or the cross member way or making your own.

 

Hopefully with the new surgeance of people doing these swaps, more companies will make a reasonably priced alternative for those who wish to save some money. I am working with another person to develop mount kits right now, but they won't be out for atleast another month and will be priced far below any other major competitor.

Night

 

Good information on the mounts. My shop might be able to make something also. I'm sure we could. The thing is I most likely wont be ready to do the swap untill around March if all goes well. So by that time hopefully there should be a few companys out with these mounts. I'll also have to look into the wiring some more. I can't wait to start working on this project.