Tap Set anybody?
#1
Tap Set anybody?
Yes, I did post this in 2 different sections. More people check the general section rather than the regional...without further ado..
Yo.
So like, I just totally bought a brand new Turbo Elbow/O2 housing. But the stupid Bung is too big for the o2.
Soo..I need a person in orange county/Anaheim/Garden Grove/LA County/anywhere close here..to let me borrow a tap set.
It's gonna be a 13/32 Drill bit w. 1.50 tap. I'll come to your house..do it and take off. It should take no more then 30mins of actual labor.
so if anybody, on those certain area listed above, can help me..it would be much appreciated.
Needs to be done Before Thursday..7,28l05
Yo.
So like, I just totally bought a brand new Turbo Elbow/O2 housing. But the stupid Bung is too big for the o2.
Soo..I need a person in orange county/Anaheim/Garden Grove/LA County/anywhere close here..to let me borrow a tap set.
It's gonna be a 13/32 Drill bit w. 1.50 tap. I'll come to your house..do it and take off. It should take no more then 30mins of actual labor.
so if anybody, on those certain area listed above, can help me..it would be much appreciated.
Needs to be done Before Thursday..7,28l05
Thread
Thread Starter
Forum
Replies
Last Post