KA24E Parts, SR20DET SMIC Will Ship All Parts -- Upstate NY Pickup
07-09-2006, 11:47 AM
#1
Registered User
Thread Starter
Join Date: Oct 2005
Location: Upstate, NY
Posts: 125
KA24E Parts, SR20DET SMIC Will Ship All Parts -- Upstate NY Pickup
Got a bunch of misc. parts up for sale:
Everything off of my KA24E setup, including the engine will be parted out. I will get a list, and pictures up later on in the day today. Also, I have the SMIC setup off of my sr clip, it doesn't have the plastic cowl or hotpipe with it, but everything else is there.
The KA has 175k miles on it, and was an auto. Ran perfect when pulled, slight chain rattle was all!
The only things I do not have is the USDM radiator, wiring harness is incomplete, motor mounts (have a tranny mount, no crossmember), and throttle body!
Complete SOHC Intake - $25 (Will part out). Boot has no rips, only screw tabs are cracked on the long plastic pipe where screw holes are.
SMIC setup off my front clip - PENDING SALE (Will part out). The wort damage is the bottom fins, which still won't make much of a difference.
KM/H Cluster with SOHC Tach installed - $20 (Will part out).
USDM Radiator Shroud, no cracks, no broken pieces - $20
Ground Cable - $2
Coil + Chip - $10
Coolant Resevoir (cracked, could epoxy) - $5
Carbon Canister - $5
Fan Sensor Wire (for OEM elec. fan) - $2
S14 Fuse Panel Cover - $10
Sunroof Latch - $15 (Comes with anchor plate)
Auto. Tranny Shifting Resistor - $5
Transmission Mount (still good, not broken) - $5
5spd. Radio Bezel (auto. trim installed) - $10
Rear Seatbelts - $5/each
Stock Fuel Pump - $5
Battery Box - $10
SR20 Clip Parts:
Carbon Canister - $5
Turbo Heat Sheild - $2
Oil Catch Tank - $5
Power Cable (to starter solenoid) - $5
AIV Unit - $5
EGR Tube (I can cut the tube for the threaded piece if you want to make a plug for the AIV) - $2
SHO Taurus Fan (No plug for it) - $30
Auto. Driveshaft Yoke - $5
SOHC P/S Resevoir - $5
SOHC P/S Pump - $10
A/T Shifting Unit - $5
KA24E Heat Sheild - $5
Fuse Panel Covers - $2/each
Center Vent Unit - $5
PM/email (ebay172@yahoo.com)/instant message (HardTrukr) me with any requests and your offers!
Everything off of my KA24E setup, including the engine will be parted out. I will get a list, and pictures up later on in the day today. Also, I have the SMIC setup off of my sr clip, it doesn't have the plastic cowl or hotpipe with it, but everything else is there.
The KA has 175k miles on it, and was an auto. Ran perfect when pulled, slight chain rattle was all!
The only things I do not have is the USDM radiator, wiring harness is incomplete, motor mounts (have a tranny mount, no crossmember), and throttle body!
Complete SOHC Intake - $25 (Will part out). Boot has no rips, only screw tabs are cracked on the long plastic pipe where screw holes are.
SMIC setup off my front clip - PENDING SALE (Will part out). The wort damage is the bottom fins, which still won't make much of a difference.
KM/H Cluster with SOHC Tach installed - $20 (Will part out).
USDM Radiator Shroud, no cracks, no broken pieces - $20
Ground Cable - $2
Coil + Chip - $10
Coolant Resevoir (cracked, could epoxy) - $5
Carbon Canister - $5
Fan Sensor Wire (for OEM elec. fan) - $2
S14 Fuse Panel Cover - $10
Sunroof Latch - $15 (Comes with anchor plate)
Auto. Tranny Shifting Resistor - $5
Transmission Mount (still good, not broken) - $5
5spd. Radio Bezel (auto. trim installed) - $10
Rear Seatbelts - $5/each
Stock Fuel Pump - $5
Battery Box - $10
SR20 Clip Parts:
Carbon Canister - $5
Turbo Heat Sheild - $2
Oil Catch Tank - $5
Power Cable (to starter solenoid) - $5
AIV Unit - $5
EGR Tube (I can cut the tube for the threaded piece if you want to make a plug for the AIV) - $2
SHO Taurus Fan (No plug for it) - $30
Auto. Driveshaft Yoke - $5
SOHC P/S Resevoir - $5
SOHC P/S Pump - $10
A/T Shifting Unit - $5
KA24E Heat Sheild - $5
Fuse Panel Covers - $2/each
Center Vent Unit - $5
PM/email (ebay172@yahoo.com)/instant message (HardTrukr) me with any requests and your offers!
Last edited by YFZ460; 07-18-2006 at 04:41 PM.
07-15-2006, 07:49 PM
#2
Registered User
Join Date: Sep 2004
Location: DA Boogie Down BRONX
Posts: 85
where upstate are you??
07-15-2006, 08:52 PM
#3
Registered User
Thread Starter
Join Date: Oct 2005
Location: Upstate, NY
Posts: 125
I'm in the Albany area (Berne specifically). I know you don't know where it is so the zip code is 12023.
The engine is located at my father's shop 20 minutes from Albany, more specifically in Colonie which is zip code 12205.
The engine is located at my father's shop 20 minutes from Albany, more specifically in Colonie which is zip code 12205.
07-17-2006, 03:45 PM
#4
Registered User
Join Date: Sep 2004
Location: DA Boogie Down BRONX
Posts: 85
07-17-2006, 07:46 PM
#5
Registered User
Thread Starter
Join Date: Oct 2005
Location: Upstate, NY
Posts: 125
Will send it tomorrow for you. As for any parts, I will get better pictures if you want!
Thread
Thread Starter
Forum
Replies
Last Post
rancidnsx
Private For Sale / Wanted
0
06-04-2004 12:12 AM
swprosr20det
Private For Sale / Wanted
10
02-07-2004 07:44 PM
