Where did you get yours?
#1
Where did you get yours?
Hey this is for anyone with an Sr20 in the midwest. Where did you get? How much did it cost? DIY or shop install, if installed how much did that run you? Was it worth it? Name and Web address or # of the shop?
Thanks, I appreciate it
Thanks, I appreciate it
#3
#5
thats what i would do.
#7
well when i had my 240 i talked to slick and the cheapest way to do the SR swap was around 5,200 and the high end was around 6,500 but thats going all out, turbo timer FMIC etc...
and a SR motorset is a lot more than the CA motorset but then again there is a lot of work needed on the CA to get it up to par cause they are older. Either way you can do this **** yourself but just send out your ECU to get it converted and then hope you get an uncut wiring harness. When ever you decide to do this let me know cause i'm sure i'll be around still and can give you a hand.
and a SR motorset is a lot more than the CA motorset but then again there is a lot of work needed on the CA to get it up to par cause they are older. Either way you can do this **** yourself but just send out your ECU to get it converted and then hope you get an uncut wiring harness. When ever you decide to do this let me know cause i'm sure i'll be around still and can give you a hand.
Thread
Thread Starter
Forum
Replies
Last Post
jbask
Turbo Motor
7
11-18-2004 02:18 PM
StanBo
General
1
10-07-2002 01:40 PM