Post your 1/4 mile times, as well as what setup you're running.

 

wrong forum

 

My 240 runs 0.0 in the 1/4. I hope to improve my time with the addition of my SR20.

 

dude! you cant improve on a 0.0!!! yOU'Re1 240 is faster than the spped of lizight!!1

 

I ran a 15.4 on my stock '91 240. I keep the spark plugs clean and I make sure everything is running real strong.

 

well i ran a 17.6 with my kae knocking, missfiring, and smoking the whole way down the track BEAT THAT WITH AN SR! lol j/k

 

i hit a 15.5 at the track. i have a 96 240 base model, hks exhaust no pipe, injen intake, and custom short shifter.

 

Ran a 13.0@105 with a ****ty 1.9 60' time. This was done on a S13 SR20DET motor with minimal bolt-on mods.
Power enhancing mods were:
Full 3" exhaust
Intake
boost controller (boost at 15psi)
Front mount intercooler
ACT 2100 clutch
Limited slip differential
BFG drag radials

 

^what were your sus. mods?

 

Suspension mods:

• Tein HE coilovers
• Whiteline polyurethane bushing kit (Tension rods, subframe spacers, rear upper and lower control arms, front control arms.)
• Front/Rear strut tower bars

 

I don't even have my car up and running but i am in the middle of the sr blacktop swap. but i have a s13 and am putting on apex s-afcII, large front mount intercooler, blitz ss-bov. greddy profec b specII, vlsd swap, and splitfire ignition, 3inch greddy downpipe. i want to push about 10psi. is this a good start towards low 13's. I also am planning on getting the greddy piggy back system.