Sinfestboy

and the lady is going to give me a quote with her reccomendations for parts, but I have the final say on stuff like clutch, intercooler, radiator, etc...
So what do YOU guys reccomend for new parts for the new engine?

RuizXIII

iTrader: (2)

is the lady hot?

coolant temp sensor

silentvoice19

a ***** magnet definatly i have one in my 240.

neville610135

you need one? mine came with one...haha

what price did they quote you to install it?

epp_b

eeewwww...this thread is going in the wrong direction

Certainly the clutch and radiator will need replacing.

Sinfestboy

nooooo come on now, give me a little more credit than that. Look at my registration date. What I mean is like what BRAND and/or size of different parts, like should I leave the stock intercooler, or get a big ol spearco one? I allready know I want a dual stage turboxs boost controller (I'd prefer 3 stages but they only make either 2 or 4). And what kind of clutch? thats one thing I really dont know **** about - clutches - so what type and brand do you guys run?

Sinfestboy

oh and they said 3500+ installed

epp_b

My clutch is a 175,000 KM old and in need of replacing...when I can afford it. So I don't think I'm allowed any say on clutch recommendations

neville610135

thats hella cheap. my bro's MR2 turbo install would have cost him almost as much as the engine.

mine's auto, cant help you there

95240sxmjm

iTrader: (1)

at least a act street performance

derrick_240

is that including the engine, or you had to buy that yourself?

DriftX

3500 plus installation? dear christ.

neville610135

yes?

bump

Urban Outlaw

the clutch is a good idea while the motor is outta the car. What year 240 u got? cause my stock S14 KA radiator worked fine when my rb20 was stock. Just get a good set of fan on that B. I'd say do a basic tune up. replace spark plugs, timing belt, etc. check on the gaskets and seals. might save u money down the road.

Also thru personal experience. take a lot of pictures of the install. From the wiring harness to them puttin the motor in. And if u can go over everything b4 they do it. I got pretty ****ed over cause I wasn't there for the first time it got put in. and had to pull the entire motor and redo everything.