Go Back  S-Chassis.com > Market Place > Private For Sale / Wanted > For Sale - Cars For Sale
Reload this Page >

1995 240SX – LS6 w/ built 4L80E w/ Transbrake, Kouki Conversion w/ Fresh Paint

For Sale - Cars For Sale Includes all models. If you have a vehicle for sale, place it in here.

1995 240SX – LS6 w/ built 4L80E w/ Transbrake, Kouki Conversion w/ Fresh Paint

Old 06-18-2018, 06:07 AM
Registered User
Thread Starter
Join Date: Jun 2018
Location: Arlington
Posts: 0
1995 240SX – LS6 w/ built 4L80E w/ Transbrake, Kouki Conversion w/ Fresh Paint

Location: Arlington, VA
Contact: LS14auto(at)gmail(dot)com
Full Album: https://imgur.com/a/FScAQRO
Price: $17,500 or best reasonable offer, No Trades

Brief history:

I purchased this car in 2005. At the time it was mainly stock but had a stock SR20DET with a knock. I was able to drive it home, pull the motor and replaced it with another stock SR. I eventually upgraded to a GT30 with supporting mods and had the old SR rebuilt with upgraded internals/components. Around this same time in 2007 I suffered an injury that prevented me from driving a manual. I thought about selling the car then, as it was my second/project car, but instead decided to pursue an automatic option that would allow me to drive it. Below is the result, a purpose built car that has a lot more potential because of the quality and ‘beefiness’ of the parts used and attention to detail.

This car was finished in August 2015, but has mainly sat in my garage the past three years, hence the reason why it’s time to sell it. In that time I have put less that 1,200 miles on it, and 600 of that was driving from Louisville, KY to D.C. Also, it has never been to the track since I’ve owned it.

I covered the main areas, but I am sure I am leaving a few things out. Please feel free to message me with any questions.

1995 240sx with 164,100 on chassis

Kouki Conversion, bodywork, and custom paint (160 total hours) by Phantom Autobody

Powerplant and Drivetrain:
LS6 from a 2001 ZO6 with 46,000 miles

FAST ELECTRONICS 102mm intake w/ Professional Products complete Fuel Rail Kit

Jake’s Performance Stage II 4L80E w/ Trans Brake, custom trans mount, and tranny cooler

Jake’s Performance custom converter (Stall 3500/ Shift Point 6600)

Sikky mounting kit/custom oil pan/headers/power steering/etc

PSI custom harness, reflashed PCM, DBW and ISS enabled for 4L80E

Q45 LSD Diff Final gear ratio: 3.54 / 300ZX TT Driver Side Axle (installed on driver side of 240SX) and Infiniti Q45 Driver Side Axle (installed on passenger side of 240SX).

Koyo Radiator


APEXi N1 ExV Coilovers

Energy Suspension Hyper-Flex complete bushing replacement

SPL SOLID Differential Bushings

SPL SOLID Subframe Conversion Bushings


CTS-V front brake calipers with 13” Mitsubishi Evolution Evo 8/Evo 9 Performance Brake Rotors (Front)

300zx rear brake caliper with Power Stop K666 Rear Ceramic Brake Pad and Cross Drilled/Slotted Combo Rotor

Enkei RPF1- Racing Series 17x9.5 18mm Offset (rear) 17x8 (front)

Yokohama S.Drive High Performance Tire - 255/40R17 94Z and 235/40R17 90Z

Electronics and Misc:
AEM Wideband

AEM oil pressure gauge

12” electric fan with thermostat

Optima Batteries RedTop Battery relocated to the trunk in xx battery box

T-Spec V12-CBF140 V12 Series 140 Amp Circuit Breaker

Walbro 255lph In-Line Fuel Pump

New Brake Master Cylinder

New rear glass and several pieces of rubber trim replaced.

I tried to be as thorough capture the known issues in the Imgur album with photos and descriptions, most are very minor, but wanted to be as transparent as possible. Here is a summary:

Two hairline crack in the brake light (was like that when I bout the lights)

Drivers seat lumbar worn through

1/4” scratch and small dent in paint above driver’s side rear wheel, which is very minor, but the most significant s issue with the paint. There are ~2 other minor blemishes from in the front bumper area/hood from road debris, but barely noticeable and unable to capture in a picture. Other than that, the paint is pristine.

No A/C

No trim around shifter

Crack in trim below radio

Crack in passenger’s side door handle trim

Radio currently doesn’t work and I have a replacement I will swap or give to new owner.

Discoloration on sunroof trim, sunroof is functional and no leaks.

Discoloration on windshield wipers

Gop of back seat has a few small cracks in the leather

Two small surfaces area rust spots in trunk

1/8" cut in passengers side door

glued seem behind drivers seat separated
Attached Thumbnails -240phantomreducedevensmaller.jpg  
hennajapagaiji is offline  
Related Topics
Thread Starter
Last Post
For Sale - Cars For Sale
01-03-2011 11:49 AM
For Sale - Cars For Sale
04-09-2008 01:14 PM
For Sale - Cars For Sale
11-25-2006 08:56 AM
Unholy FD3S
For Sale - Cars For Sale
11-19-2006 03:53 PM
Show and Shine
07-23-2004 08:48 PM

Thread Tools
Search this Thread
Quick Reply: 1995 240SX – LS6 w/ built 4L80E w/ Transbrake, Kouki Conversion w/ Fresh Paint

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.