Justin.b

I just picked up some of these harnesses the other day from hms motorsports (www.hmsmotorsports.com) and I have to say they kick much ***. The cost was $150/each.

After installing them I went for a little run and founf that I could take one of my favorite onramps at about 12mph faster than before just because I don't have to brace myself with my knees, the wheel and shifter.

I just wsh the car had some of the speed to back up the serious-looking interior. But itdoes handle very well.

-Justin

-HyJynX-

Time for the swap? Those harnesses are 4 point correct?

Justin.b

Yup, those are 4 point. No swap. I think I'm going turbo KA on stock compression / bottom end. They're cheap to replace if I make it go kaboom.

-Justin

-HyJynX-

Either way, its a 240 I gatta get my seats and harnesses in a few weeks

WILDACEXXX

very nice justin, where did u secure the harnesses to?

rudeboy

here is mine...you can kinda see where it's bolted



i have a 3 point sparco

Justin.b

My harnesses are connected to the stock mounting points for the lap belt for the lower two points and to the harness bar of the roll bar for the upper two points.

-Justin

Strizzy

Hey rude I was thinking about that same set up. How is it? Did you get the 3 point snap in type?

rudeboy

i like it. has tons of adjustability
and it has a regular style buckle
it works and new they are around $75
plus the sparco is a real brand..unlike weapon_r or some crap...lol