ErnGotti's RB20 swapped 91 coupe
#46
wow...just wow....
I hope you find a way to get those bolts out without striping the treads on the block
im gonna be watching this thread closely because Ihave a coupe' andI would like to go rb20 in the far distance future lol
Good luck
I hope you find a way to get those bolts out without striping the treads on the block
im gonna be watching this thread closely because Ihave a coupe' andI would like to go rb20 in the far distance future lol
Good luck
#47
Well guys, here's a trick:
I was told this by a guy I know.
Weld a washer (weld the hell out of it) to the bold head. Then weld the hell out of a nut to the washer, starting at the bottom (on the inside) then work upwards until it almost bubbles out. I'm going to need new studs but oh well. ARP's are in order.
I was told this by a guy I know.
Weld a washer (weld the hell out of it) to the bold head. Then weld the hell out of a nut to the washer, starting at the bottom (on the inside) then work upwards until it almost bubbles out. I'm going to need new studs but oh well. ARP's are in order.
#50
Update: Got the 1.2mm Cometic in today. Standard 80mm bore. However, there is NO WHERE WHATSOEVER for the 3 bolts I stripped to go. Maybe they aren't bolts. But either way, I got the 14 bolts out that actually go THROUGH the gasket. Any suggestions as to why the Head won't pop off? I pried like a **** and it wouldn't BUDGE.
#52
http://forums.********.com/zerothread/325325
Found this little helper. The 3 bolts I stripped have nothing to do with the head. The 3-10mm ones are the ones I missed.
Found this little helper. The 3 bolts I stripped have nothing to do with the head. The 3-10mm ones are the ones I missed.
Thread
Thread Starter
Forum
Replies
Last Post
JDMuseR
For Sale - Wanting To Buy (WTB) Or Trade (WTT)
5
09-25-2007 12:31 PM
550cc, 6969yahoocom, connection, diagram, fmic, injectors, install, pulley, rb20, rb20det, rich, runs, sarkastik, underdrive, vacuum